DN16-17 RELATED
PIECES Insulator
Block (2 req'd unless yours are OK) 160-C1
Carb Gasket Kit (Included with DN16-17) Throttle
Springs also included.
USING
ON AN R 16 ENGINE Can
be installed on R16 when the 1500 insulator blocks and
gaskets are used. (2 of #161-86 and 1 of #160-C1
gasket set) Using these on a 1600 also requires you
use just one of your choke cables. You will need to
carefully strip off some of the outer cable housing so
the inner cable extends out much farther. Depending on
how your manifold is configured ou may also need to
remove some studs and replace them with bolts to hold
the 1500 insulators on. Same size carbs, just
different design. They cannot be used on a 70 1600 and
meet emission requirements as they have no provision
for the intake manifold smog valve hoses.
SPL310
Parts from Rallye Enterprises, Ltd.
We
have now run out of these carburetors. We DID however
find a set we had in storage that is on the ODDS and
ENDS page.
It was missing a few minor parts that someone swiped
probably decades ago. We had to locate them. They are
just some parts on the end of the throttle shaft and
are not parts that wear out. We used what parts ones
we could acquire and found a couple of little used
parts
For
all 1500's that have original dual carb
manifold.Original equipment, complete new
assemblies.