Datsun Roadster Speedo
Pinion from Rallye Enterprises, Ltd.
|
|
|
|
|
Speedo
Pinion and Holder #DU32-58
ALL
1600 and 65-70 4 speed cars with 3.9 Rear Axle
Gears
|
Speedometer
inoperative? After the most-likely cable; this is 2nd
on the list of possibilities. Remove this from
transmission by removing tiny bolt next to where
speedo cable connects and wiggle it out. When
reinstalling push in GENTLY allowing pinion to engage
trans internal gear. At the end of your cable; between
the cable end and the transmission you should have a
small 90 degree gearbox converter. Cable should not be
screwed on to transmission directly on a 4-speed.
Continued cable breakage would be the result. Original
pinions were brass. They were also designed to break
before the internal gear was damaged; but plastic
pieces floating in the transmission oil after a pinion
failure are a lot more forgiving than brass
shavings...
|
SP311 - SPL311 - SPEEDO
PINION GEAR AND HOLDER
|