Datsun
Roadster Parts from Rallye Enterprises, Ltd.
|
BASIC
INFORMATION
It
is easy for the camera to lessen or worsen the
dings. We try to give a true representation of the
situation. Pieces may have other dings that you may
be unable to see, but can be felt by sliding your
hand over the area. Any and all used pieces would
need at least a good polishing to restore
them.
|
SIDE
MOULDING Convex 67.5-70 Right Front,
#DU80-34
|
|
|
SIDE
MOULDING Convex 67.5-70 Right Front, #DU80-35
The
above two pictures are of the same area on the same
piece, just from slightly different angles. There is
not a crease down the length, that is a
shadow.
|
|
|
SIDE
MOULDING Convex 67.5-70 Right Front, #DU80-36
This
piece only has he slight crease as shown.
|
|
SIDE
MOULDING Convex 67.5-70 Right Front,
#DU80-37
This
piece has no dings to speak of. It does not lie flat
on the table, which isn't out of the ordinary if
EXTREME care is not used removing the pieces from the
car. With this short of a piece, with 3 clips I do not
think this will be a problem on the car. A
professional trim person could of course improve it
but again, I don't think it will be necessary. There
is no area on it that indicates a bend, the curve is
extremely gradual and goes away when you push down
gently on it on the table.
|
|
|
|