Head
has about .031" crown to take out of top middle. Cutter
should be stopped before it reaches the ends of the head;
so the area under the end towers are only skimmed.
Bottom
has about .035" warp
Average
thickness at front of head is 4.507"
Average
thickness of rear of head is 4.515"
With
so little cut off this head in the past; this would be a
good candidate if you can find a good shop that does oven
straightening; so as to minimize the surfacing that is
necessary.
Cam
value is in core only. Rockers are old style and are
harder on a cam than the "new" style.
Subtract
$80 if you don't want cam.
Also subtract $80 if you don't want valves and
springs
DATSUN
U20 USED HEADS
Info
For
General Info on U20 Heads click on Rebuilt
Heads
Info.
