Head
has about .007" crown to take out of top middle. Cutter
should be stopped before it reaches the ends of the head;
so the area under the end towers are only skimmed.
Looks
to be flat on bottom.
Average
thickness at front of head is 4.468"
Average
thickness at rear of head is 4.471"
Bolt
on front cam tower where upper chain guide attaches is
broken off in tower.
Complete
head; has cam, rockers, valves, rocker pivots, t/stat
housing (spacer) and water outlet
If
these parts are not wanted; subtract from listed
cost:
Cam
$180
Rockers, Rocker Pivots and Holders $180
Valves $80
Springs, Retainers etc. $80
T/stat Housing and Water Outlet $140
DATSUN
U20 USED HEADS
Info
For
General Info on U20 Heads click on Rebuilt
Heads
Info.